Poremet has high strength and durability by high temperature sintering (diffusion-bonded) and it is supported dutch woven wire mesh 12/64 mesh in the fourth and fifth layer. Filtration ratings from 2 microns up to 100 microns are available. It is usable for uniform filtration and high pressure or high viscosity environment.         
 
                                       

       


                                                     
                         
          
       
 
                                                                                         
     
Material - Standard material stainless steel 316L (SST316)
Special material Hastelloy, etc.
Fabrication - Poremet is easily formed, sheared and punched.
It is also easily welded using TIG or Plasma welder.
Standard panel sizes  - 500 x 1,000 mm.
                                   - 1,000 x 1,000 mm.
                                   - 1,200 x 1,200 mm.
Clean ability - Reusability and long life by high pressure jet water cleaning, ultrasonic or furnace heat treating.
Special order - Other specifications are available depending on Customer’s needs or requirements.

First layer: 100 mesh as protection.
Second layer: filter mesh which varies on requirement.
Third layer: 100 mesh again as protection.
Fourth layer: 12/64 mesh as support.
Fifth layer: 12/64 mesh as support placed cross to the fourth layer.
                                                                  

       Flow Rate VS Pressure